Operating instructions

25
Emergency Stop Buttons
Emergency stop buttons
There are two buttons and they are located on top of the right and left cabinets of the laminator.
They stop the rotation of the rollers and should only be used in case of an emergency. Once
pressed these buttons lock, and must be rotated to be reset before the laminator can be used
again. See also safety information section.
Emergency Stop Trip Wire
Emergency stop trip wire
One emergency stop trip wire is located at the front side close to the bottom side of the machine.
The switch is installed at the front of the right cabinet. Touching the wire by foot or hand stops the
rotation of the rollers and should only be used in case of an emergency. Once activated this switch
locks. The emergency stop trip wire must be reset by pulling the blue button on top of the switch,
before the laminator can be used again. See also safety information section.