Operating instructions

Control Panel

Foot pedal

The foot pedal is connected by cable to the machine and has to be positioned at the floor in front of

the laminator.

The foot pedal can be used to rotate the rollers in forward mode or in slow (snail) mode. Keep the

foot pedal pressed to operate the rollers. Release the foot pedal to stop rotation of the rollers.

Slow (snail) mode

WARNING:

In this mode, the in-running nip at the

front-side

is not protected by a safety device -

the rotation of the rollers will

not

stop

automatically when human body parts, clothing, long hair,

etc. reach in the in-running nip.

Press the button to activate the slow mode function, an audible signal will be heard and the LED [6]

comes on.

Press the foot pedal, the machine will rotate slowly forward at a fixed speed of 0,5 m/min (20

inch/min). The LED [8] will come on.

Releasing the foot pedal to stop rotation of the rollers.

Press the button again to deactivate the slow mode function, LED [6] will then go off.

Changing from slow-mode to normal running mode without stopping (to prevent

stop marks on the substrate):

 during slow mode, keep the foot pedal pressed and press the forward mode button, but do not

release the foot pedal yet.

 next, release the foot pedal.

 finally release the forward button.

Changing from normal running mode to slow-mode without stopping:

 during forward mode, press the slow mode button, an audible signal will be heard and the LED

6 comes on.

 press the foot pedal.

 releasing the foot pedal will stop rotation of the rollers.