Operating instructions

22
Control Panel
The laminators control panel is situated on the front right.
The control panel of the 60C is divided into 2 sections, motor control section and display section.
The control panel of the 60S is divided into 3 sections, motor control section, display section and
heater control section.
MOTOR CONTROL SECTION
The rotation of the rollers is started as follows:
1. Set the machine for the necessary process as is prescribed by Seal Graphics.
2. Select the necessary mode to operate the machine.
Normal forward mode
To operate the machine continuously forward, press the start button [ 9 ]. The LED [8] will come on.
Set speed higher than “1”, the rollers will start rotating.
The machine is stopped by the following:
1. Press the Stop button – Normal stopping mode.
2. Interruption of the opto-electronic protective device by finger, hand or material, The LED [14]
will be off.
3. Press either of the two emergency buttons.
4. Press the emergency stop trip wire by foot or hand.
5. If a motor overload occurs, LED [15] will come on on.
6. Briefly operate the foot pedal for a very short time.
7. Set the speed adjustment control knob at 0.
The rollers stop rotating when the speed is set at ‘0’. However, the operating mode is still
active.
Reverse mode
To operate the machine in reverse, keep the reverse button pressed. The LED [4] will come on. The
rollers will rotate in reverse at a fixed speed of 0,5 m/min (20 inch/min).
Release the button to stop the rotation of the rollers.
Using reverse mode can damage the process. Before using this mode, be
sure that is necessary.
WARNING:
In this mode, the in-running nip at the
backside is not protected
by a safety device -
the rotation of the rollers will
not stop
automatically when human body parts, clothing, long hair,
etc. reach in the inrunning nip.