Operating instructions

13
General Information

Power Sources
– Only connect the laminator to the power supply specified on the
identification label. Refer to the “Specifications” chapter in this manual for more information.

Water and Moisture
– Install an RCD (GFI in U.S.A.) in the buildings electrical supply if the
laminator is used near water or in an area of high humidity.

Environment
– Use your laminator in the cleanest, most dust free environment possible to
produce the highest quality output. The Image 60C consumes approximately 0.25 kW and the
Image 60S consumes approximately 4 kW of electricity. Because of the heat generated by the
Image 60S, the laminator should not be in the same room as an electrostatic plotter, etc.

Working Space
– The laminator requires a working area large enough to allow the safe and
efficient use. An area 4,5m x 6,0m (15ftx20ft) would be the smallest recommended. See
previous page.

Rollers
–
NEVER
cut or slice directly on any of the roller surfaces as any resultant damage is
not covered by the warranty.
ALWAYS
use cutters with enclosed blades to prevent cutting
rollers and to avoid expensive replacement costs.

Do not
feed objects such as staples, paper clips and rough or abrasive materials through the
laminating rollers. Keep all objects such as tools, rulers, pens, markers, etc. away from the
roller opening. Refrain from leaving such items on the feed-in table to prevent them accidentally
being fed into the rollers.

Servicing and Replacement Parts
– Refer all servicing to your distributor. Servicing by any
unauthorised technician voids the warranty.
WARNING:
When the laminator is not in use , always ensure that the top roller has been raised to prevent flat
spots from developing. Flat spots will effect the quality of the output and is not covered by the
warranty.
General Use
The IMAGE 60C/S greatest quality is its simplicity. With it, a low-skilled operator is able to mount
and laminate quickly, even continuously.
SAFETY IS IMPORTANT
DO NOT OPERATE YOUR LAMINATOR IN AREAS OF EXTREME HUMIDITY. KEEP HAIR,
JEWELLERY AND LOOSE CLOTHING AWAY FROM THE LAMINATOR DURING OPERATION.
ALWAYS TURN THE LAMINATOR OFF AND DISCONNECT FROM THE ELECTRICAL SUPPLY
BEFORE OPENING THE SIDE CABINETS WHICH HOUSE THE INNER WORKINGS OF THE
LAMINATOR.