User manual

English
Process Control Sheet
Note:
We recommend that you make a photocopy of this page. With each successfully run
application, record the process and settings and a diagram of the webbing procedure.
Keep the record so the application can be repeated at a later date.
Hint:
If a standard image is made available for each new process then sales materials and
samples can be developed for reference.
LAMINATOR SETTINGS
Media: ____________________________________________
Process: __________________________________________
Application Use: ____________________________________
Top Front Unwind Shaft: ______________________________
Top Front Wind-up Shaft: _____________________________
Top Rear Unwind/Wind-up Shaft: _______________________
Bottom Front Unwind Shaft: ___________________________
Bottom Front Combi Shaft: ____________________________
Bottom Front Combi Shaft: ____________________________
Top Rear Wind-up shaft: ______________________________
Bottom Rear Combi Shaft: ____________________________
Front Control Panel Settings
Top Roller Temp: ___________________________________
Bottom Roller Temp: ________________________________
Main Roller Pressure: ________________________________
Pull Roller Pressure: _________________________________
Pull Roller Clutch pressure: ____________________________
Cooling Fan: On / Off ________________________________
Motor Speed Setting: ________________________________
WEBBING SETTINGS
Web Tension Top:
Light / Med. / Heavy _________________________________
Web Tension Bottom:
Light / Med. / Heavy _________________________________
Nip Opening: _______________________________________
Images: Sheet Fed / Roll _____________________________
Top Splitter Bar: [Over/Under] _________________________
Bottom Splitter Bar: [Over/Under] _______________________
Front Chill Idler: [Over/Under] _________________________
Rear chill Idler: [Over/Under] __________________________
Machine Operation 51