How to Guide
PRODUCT
DATA SHEET
DESCRIPTION: Ready-to-use premium low gloss sealer that penetrates
deeply to seal and protect painted, stained or bare concrete. It goes on milky
white and dries to a low gloss finish, enhancing the natural character of your
surface. CLEAR-SEAL is a durable urethane-fortified acrylic sealer with low
odor, and low VOCs, so it’s easy to work with and safe for the environment. It
has excellent chemical resistance and repels stains.
Typical Uses:
3 Pool Decks 3Patios & porches
3 Driveways & Garages 3 Sidewalks
Important: Read all directions thoroughly. Recommended: Wear gloves and
safety glasses.
SURFACE PREP*: Note: The surface should be clean and dry. You may need
an oil stain remover such as SEAL-KRETE
®
Oil Stain Remover to lift stubborn
oil stains. Pressure-washing is recommended.
Bare Concrete: Concrete must have cured for a minimum of 30 days.
Etch smooth-finished concrete, such as basement or garage floors with a
concrete etching solution like SEAL-KRETE Clean-N-Etch. Note: If etching
with muratic acid the area must be neutralized before proceeding. For
more information visit www.seal-krete.com.
Painted Surfaces: For use over one-part water-based coatings only;
not recommended over acid-based stains or oil-based coatings.
Freshly painted or stained surfaces must have cured for a minimum of
72 hours. Painted surfaces must be sound (not blistering or peeling).
Existing painted surfaces should be cleaned with a solution of Trisodium
Phosphate (TSP) and water. Rinse well and allow to dry.
APPLICATION: Read “LIMITATIONS” section before use. This product is ready
to use; do not dilute. Stir gently; do not shake. Apply in light, even coats. One
coat is recommended; however, over porous surfaces, like saltillo tile, or
when a higher sheen is desired, apply a second coat. Note: Sealer goes on
milky white but dries clear.
Roller: Dampen roller, remove excess water, then saturate roller with
product. Keep a wet edge while rolling. Do not allow to puddle, foam or
run. (Use a 1/4” nap for smooth surfaces, 3/8” nap for rough or porous
surfaces.)
Pump Sprayer: Set at a fine spray and apply using a circular motion.
To eliminate puddling or to achieve a more uniform finish, backroll
immediately after spraying.
COVERAGE: 150-500 sq.ft. per gallon, depending on surface porosity.
DRY TIME: Dry to touch in 1 hour at 77°F (25°C) 50% RH. Recoat in 2 hours.
Dry to foot traffic in 24 hours. Will accept vehicular traffic in 72 hours. Dry
times should be extended in colder climates.
CLEAN-UP & STORAGE: Clean tools with soap and water immediately after
use. Store in a dry area. KEEP FROM FREEZING.
MAINTENANCE: Clean with a mild soap and water solution. Do not use
solvent-based cleaners.
LIMITATIONS: Temperatures should be 50° to 90°F (10° to 30°C) and should
not fall below 50°F (10°C) within 24 hours of application. Do not apply if rain
is expected within 12 hours. Do not use over acid-based stains, 2-part epoxies
or oil-based paints. Do not use on glazed tile. Do not use in areas subject to
hydrostatic pressure. Smooth-finished concrete may be slippery when wet;
consider using an anti-skid additive like SEAL-KRETE Clear Grip on high foot
traffic areas.
*Sanding or removing paint containing lead may be hazardous. For information
contact the National Lead Information Center at 1-800-424-LEAD or www.
epa.gov/lead.
CAUTION: CONTAINS PROPYLENE GLYCOL PHENYL ETHER. MAY CAUSE
EYE AND SKIN IRRITATION. USE ONLY WITH ADEQUATE VENTILATION.
FIRST AID: In case of eye contact, flush with water for 15 minutes. If irritation
persists, get medical attention. In case of skin contact, wash thoroughly with
soap and water. If swallowed, drink 1–2 glasses of water and immediately
contact medical services regarding any instructions to induce vomiting.
KEEP OUT OF REACH OF CHILDREN - DO NOT TAKE INTERNALLY.
Clear-Seal Premium Low Gloss Sealer 365001 1 gallon 0 15944 36501 6 1 00 15944 36501 3 14.38 x 14.38 x 8.5 1.02 / 37.79 4 45 cs
Carton Size Carton Size
Product No. Unit UPC Code Carton Bar Code ( W x D x H ) ( cubic ft / lbs ) Carton Qty Pallet Qty
PREMIUM LOW GLOSS SEALER
PREMIUM LOW GLOSS SEALER
CLEAR-SEALCLEAR-SEAL
CLEAR-SEAL
www.seal-krete.com