Use and Care Manual

TECHNICAL DATA
SLK-10
WET LOOK HIGH GLOSS CONCRETE SEALER
WITH TURBO SPRAY SYSTEM
™
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 800∙323∙7357
www.rustoleum.com
Form: ARJ-1985
Rev.: 020520
PHYSICAL PROPERTIES
WET LOOK HIGH GLOSS CONCRETE SEALER
WITH TURBO SPRAY SYSTEM
Resin Type
Acrylic
Pigment
N/A
Solvent
N-butyl Acetate, Acetone, Oxsol
MIR
0.40
Fill Weight
24 oz.
Volatile Organic Compounds
501 g/l
Practical Coverage
Up to 25 sq.ft./can (single coat)
Coverage will vary depending on surface porosity and texture
Dry Times @ 77º F
(25°C) and 50%
Relative Humidity
Touch
30 minutes
Handle
1 hour
Recoat
1-2 hours
Full Cure
72 hours
Flash Point
-156°F (-104°C)
Shelf Life
3 years
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.