Specifications

www.seagullmodels.com
17
Control Horn.
Mounting Screws.
Mounting Plate.
 4) Install the rudder control horn using the
same method as with the elevator control
horns.
1) Thread one clevis and M2 lock nut on
to each elevator control rod. Thread the horns
on until they are flush with the ends of the con-
trol rods.
ELEVATOR - RUDDER PUSHROD
INSTALLATION.
Right side.
Elevator control horn.
Left side.
Rudder control horn.
Elevator control horn.
Elevator pushrod.
Control horn.
Clevis.
Rudder pushrod.
Throttle.
Rudder.
Elevator.
Elevator.
2) Elevator pushrods assembly follow
pictures below.
 3) Secure the tail wheel bracket in place
using two 2x20mm wood screws. Be careful
not to overtighten the screws.
 2) Using a pen, mark the locations of the
two mounting screws. Remove the tail wheel
bracket and drill 1mm pilot holes at the loca-
tions marked.
MOUNTING THE TAIL WHEEL BRACKET.
 1) Set the tail wheel assembly in place on
the plywood plate. The pivot point of the tail
wheel wire should be even with the rudder
hinge line and the tail wheel bracket should be
centered on the plywood plate.
Fin.
Elevator.