Specifications

WWW.SEAGULLMODELS.COM
7
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
SERVO ARM INSTALLATION.
Install adjustable servo connector in the
servo arm as same as picture below:
Rudder.
Elevator.
INSTALLING THE FUSELAGE SERVOS.
.
Because the size of servos dier, you
may need to adjust the size of the precut
opening in the mount. e notch in the
sides of the mount allow the servo lead to
pass through.
1) Install the rubber grommets and brass
collets onto the fuselage servo. Test t the
servo into the aileron servo mount.
2) Secure the servos with the screws pro-
vided with your radio system.
6) When you are sure that everything is
aligned correctly, mix a generous amount
of 30-minute epoxy. Apply a thin layer
to the mouting slot and to bottom of the
vertical stabilizer mounting area. Apply
epoxy to the bottom and top edges of the
ller block and to the lower hinge also. Set
the stabilizer in place and realign. Dou-
ble check all of your measurments once
more before the epoxy cures. Hold the
stabilizer in place with T-pins or masking
tape and remove any excess epxy using a
paper towel and rubbing alcohol. Allow
the epoxy to fully cure before proceeding.
Rudder.
Elevator.