Specifications

WWW.SEAGULLMODELS.COM
3
KIT CONTENTS.
SEA12901 Fuselage
SEA12902 Wing set
SEA12903 Tail set
ADDITIONAL ITEMS REQUIRED.
15 brushless outrunner motor.
Radio 4 chanel with 2 servos.
TOOLS & SUPPLIES NEEDED.
ick cyanoacrylate glue.
30 minute epoxy.
5 minute epoxy.
Hand or electric drill.
Assorted drill bits.
Modelling knife.
Straight edge ruler.
2mm ball driver.
Phillips head screwdriver.
220 grit sandpaper.
90° square or builder’s triangle.
Wire cutters.
Masking tape & T-pins.
read-lock.
Paper towels.
HINGING THE RUDDER.
Note : e control surfaces, including the ailer-
ons, elevators, and rudder, are prehinged with
hinges installed, but the hinges are not glued in
place. It is imperative that you properly adhere
the hinges in place per the steps that follow us-
ing a high-quality thin C/A glue.
Epoxy.
Epoxy.
Hinge.