user manual

27
15.
14.
16.
Battery
INSTALLING THE SPINNER
- Install the spinner backplate, propeller
and spinner cone.
1.
e propeller should not touch any
part of the spinner cone. If it does, use a
sharp modeling knife and carefully trim
away the spinner cone where the propel-
ler comes in contact with it.
2.
INSTALLING THE HORIZONTAL
STABILIZER
- Using a ruler and a pen, locate the cen-
terline of the horizontal stabilizer, at the
trailing edge, and place a mark. Use a tri-
angle and extend this mark, from back to
front, across the top of the stabilizer. Also
extend this mark down the back of the
trailing edge of the stabilizer.