user manual

21
5.
Fuel pick up tube
Fuel ll tube
Vent tube
- Connect the lines from the tank to the
engine and muer. e vent line will
connect to the muer and the line from
the clunk tothe carburetor.
Blow through one of the lines to ensure
the fuel lines have not become kinked inside
the fuel tank compartment. Air should ow
through easily.
MOUNTING THE ENGINE
- Position the engine with the drive wash-
er (120mm) forward of the ewall as
shown.
- Use a pin drill and 4mm drill bit to drill
a small indentation in the mount for the
engine mounting screw.
1.
120mm
- Use a drill to drill the four holes in the
engine mount rails.
2.
4mm
3.
- On the e wall has the location for the
throttle pusshrod tube (pre-drill).
- Slide the pushrod tube in the ewall and
guide it through the fuel tank mount. Use
medium C/A to glue the tube to the e-
wall and the fuel tank mount.
- Connect the Z-bend in the 450mm
throttle pushrod to the outer hole of the
carburetor arm.
- Slide the throttle pushrod wire into the
tube. Position the engine between the
mounts. Use four M4x30mm machine
screws to secure the engine to the mount
as shown.