User manual SkyRaider 35-60cc Camouflage 2.20m Seagull

9
8.
Adjust the linkage so the ap is in the
mid-ap position. It may take a few tries
to properly adjust the linkage.
9.
Once adjusted, make sure all clevis re-
tainers are in position. Apply a drop of
threadlock near the clevis, then tighten
the nut against the clevis to keep the
linkage from changing length inside the
wing.
10.
3x10mm.
12.
Set the ap control at the transmitter to
the down ap position. Adjust the ap
travel at the transmitter until it matches
the control throws listed in this manual.
13.
Trim the ap linkage cover using a
hobby knife, hobby scissors and some
ne sandpaper as needed.
11.