User manual SkyRaider 35-60cc Camouflage 2.20m Seagull
33
1.
2.
Carefully bend the second brass tube up at
a 45º angle. is tube is the vent tube.
3.
Vent tube.
Fuel ll tube.
Fuel pick up tube.
Test t the stopper assembly into the tank.
It may be necessary to remove some of the
ashing around the tank opening using a
modeling knife. If ashing is present, make
sure none falls into the tank.
When satised with the alignment of
the stopper assembly tighten the 3x20mm
machine screw until the rubber stopper
expands and seals the tank opening. Do not
overtighten the assembly as this could cause
the tank to split.
With the stopper assembly in place, the
weighted pick-up should rest away from the
rear of the tank and move freely inside the
tank. e top of the vent tube should rest just
below the top of the tank. It should not touch
the top of the tank.
FUEL TANK INSTALLATION
You should mark which tube is the vent
and which is the fuel pickup when you attach
fuel tubing to the tubes in the stopper. Once
the tank is installed inside the fuselage, it may
be dicult to determine which is which.
1.
3.
2.