User manual SkyRaider 35-60cc Camouflage 2.20m Seagull

3
KIT CONTENTS
SEA348 86’’ A-1 SKYRAIDER 35-60cc
WARBIRD
1. Fuselage
2. Wing set (3 pcs)
3. Tail set (2 pcs)
4. Canopy
5. Cowling
6. Wing tube
7. landing gear Optional/Not Included
8. Fuel tank
9. Tail Gear Optional/Not Included
10. Pushrod set
11. Rocket Set With Deluxe Model
12. Drop Tanks/Bomb W/Deluxe Model
ADDITIONAL ITEMS REQUIRED
TOOLS & SUPPLIES NEEDED
in cyanoacrylate glue.
Medium cyanoacrylate glue.
30 minute epoxy.
5 minute epoxy.
Hand or electric drill.
Assorted drill bits.
Modelling knife.
Straight edge ruler.
2mm ball driver.
Phillips head screwdriver.
220 grit sandpaper.
90° square or builder’s triangle.
Wire cutters.
Masking tape & T-pins.
read-lock.
Paper towels.
� 35-60cc Engine or Electric Motor
and ESC.
� Computer radio 6-9 channel
with 8-11 servos.
� Spark plug to suit engine.
� Propeller to suit engine.
� Protective foam rubber for radio
system.
INSTALL THE AILERONS
1.
2.
3.
Epoxy.
Use a small piece of rough sandpaper to
scu the hinges for better epoxy adhesion.
Do this to all aileron hinges.
Remove the ailerons from the wing and
remove the hinges.
Apply epoxy to each hinge where it will
be inserted into the ailerons. Tip: Apply
some petroleum jelly to the metal pin
hinge area to keep epoxy from interfering
with smooth operation of hinge.
Please see pictures below..