User manual Giant Zero A6M Gas ARF 50-60cc 2

5
Hinge
Epoxy
Turn the wing panel over and deect the
aileron in the opposite direction from the
opposite side. Apply thin C/A glue to each
hinge, making sure that the C/A penetrates
into both the aileron and wing panel.
Using C/A remover/debonder and a paper
towel, remove any excess C/A glue that may
have accumulated on the wing or in the
aileron hinge area.
Repeat this process with the other wing
panel, securely hinging the aileron in
place.
Aer both ailerons are securely hinged,
rmly grasp the wing panel and aileron to
make sure the hinges are securely glued
and cannot be pulled out. Do this by
carefully applying medium pressure, try-
ing to separate the aileron from the wing
panel. Use caution not to crush the wing
structure.
Work the aileron up and down sev-
eral times to “work in” the hinges
and check for proper movement.
Note :
WING TIP BULBS
Please see below pictures.
2.
1.
5.3.
4.
ey are designed to operate on volt-
ages 12 volts.