User manual

7
INSTALLING THE AILERON SERVOS
1.
2.
2.
Ailerons servo
Flap servo
Because the size of servos dier, you
may need to adjust the size of the precut
opening in the mount. e notch in the
sides of the mount allow the servo lead to
pass through.
- Place the servo between the mounting
blocks and space it from the hatch. Use a
pencil to mark the mounting hole loca-
tions on the blocks.
- Use drill bit in a pin vise to drill the
mouting holes in the blocks.
- Apply 2-3 drops of thin C/A to each of
the mounting holes. Allow the C/A to
cure without using accelerator.
1.5mm
3.
4.
Mininum servo spec.
Torque : 66.6 oz-in (4.8 kg-cm) @ 4.8V;
83.3 oz-in (6.0 kg-cm) @ 6.0V