User manual

Cessna Turbo Skylane 182
Instruction Manual.
6
INSTALL THE AILERONS
CONTROL HORN
INSTALL FLAP CONTROL HORN
Fiberglass control horn
1.
2.
4.
3.
1.
Work the aileron up and down sev-
eral times to “work in” the hinges
and check for proper movement.
Note :
7.
- Turn the wing panel over and deect the
aileron in the opposite direction from the
opposite side. Apply thin C/A glue to each
hinge, making sure that the C/A penetrates
into both the aileron and wing panel.
- Using C/A remover/debonder and a paper
towel, remove any excess C/A glue that may
have accumulated on the wing or in the
aileron hinge area.
- Repeat this process with the other wing
panel, securely hinging the aileron in
place.
- Aer both ailerons are securely hinged,
rmly grasp the wing panel and aileron to
make sure the hinges are securely glued
and cannot be pulled out. Do this by care-
fully applying medium pressure, trying to
separate the aileron from the wing panel.
Use caution not to crush the wing struc-
ture.
- Install the ap control horn using the
same method as same as the aileron con-
trol horns.