User manual

P-47D underbolt 60 Kit

Instruction Manual.

- While holding the vertical stabilizer mly in

place, use a pen and draw a line on eachside of the

vertical stabilizer where it meets the top of the fu-

selage.

- Slide the vertical stabilizer back inplace. Using a

triangle, check to ensure that the vertical stabilizer

is aligned 90º to the horizontal stabilizer.

- When you are sure that everything is aligned cor-

rectly, mix up a generous amount of Flash 30 Min-

ute Epoxy. Apply a thin layer to the mounting slot

and to bottom of the vertical stabilizer mounting

area. Apply epoxy to the bottom and top edges of

the ller block and to the lower hinge also. Set the

stabilizer in place and realign. Double check all of

your measurements once more before the epoxy

cures. Hold the stabilizer in place with T-pins or

masking tape and remove any excess epoxy using a

paper towel and rubbing alcohol. Allow the epoxy

to fully cure before proceeding.

- Locate items necessaryto install rudder pushrod.

ELEVATOR PUSHROD INSTALLATION

- Install the elevator control horn using the same

method as with the aileron control horns.

- Position the elevator control horn on the both

side of elevator.