User manual

P-47D underbolt 60 Kit
36
Instruction Manual.
6.
7.
4.
5.
3.
- Slide the erglass cowl over the engine and line
up the back edge of the cowl with the marks you
made on the fuselage then trim and cut as shown.
- Because of the size of the cowl, it may be nec es-
sary to use a needle valve extension for the high
speed needle valve. Make this out of suf fcient
length 1.5mm wire and install it into the end of the
needle valve. Secure the wire in place by tightening
the set screw in the side of the needle valve.
- While keeping the back edge of the cowl fush
with the marks, align the front of the cowl with
the crankshaf of the engine. e front of the cowl
should be positioned so the crankshaf is in near-
ly the middle of the cowl opening. Hold the cowl
frmly in place using pieces of masking tape.