User manual
ZERO KIT
66
Instruction Manual.
- Aer the epoxy has fully cured, remove the mask-
ing tape or T-pins used to hold the stabilizer in
place. Carefully inspect the glue joints. Use more
epoxy to ll in any gaps that may exist that were
not lled previously and clean up the excess using
a paper towel and rubbing alcohol.
BUILD THE RUDDER AND FIN
1.
- Getting prepare set of rudder as photo.
2.
3.
4.
5.
- Install frame of the r udder by CA glue as photo.
- Cor vering the sheet T16 ( 2pcs) for t wo side.
- Add the white glue at all the ribs of rudder to cor-
vering the sheet T1 ( 2pcs) for two side.
- Add thin CA glue at t he tab outside the sheet.