User manual

ZERO KIT
64
Instruction Manual.
8.
9.
- Use the pen to take the mark for the hinge of el-
evator.
- Use cutter knife to cut a line for the hinge on the
horizontal stab and elevator.
10.
11.
12.
- Using a ruler and a pen, locate the centerline of
the horizontal stabilizer, at the trailing edge, and
place a mark. Use a triangle and extend this mark,
from back to front, across the top of the stabilizer.
Also extend this mark down the back of the trail-
ing edge of the stabilizer.
- Using a modeling knife, carefully remove the cov-
ering at mounting slot of horizontal stabilizer.
INSTALLING THE HORIZONTAL
STABILIZER
1.
- Install the paper hinge ( 6pcs) for both le eleva-
tor and right elevator.
- Finished for the installing elevator.
- Use sandpaper to sanding the set of horizontal
stab and elevator for smoothing the surface.