User manual

- Slide the wing panel on the aileron until there is

only a slight gap. e hinge is now centered on the

wing panel and aileron. Remove the T-pins and

snug the aileron against the wing panel. A gap of

1/64” or less should be maintained between the

wing panel and aileron.

NOTE : e hinge is constructed of a special

material that allows the C/A to wick or penetrate

and distribute throughout the hinge, secure-

ly bonding it to the wood structure of the wing

panel and aileron.

- Deect the aileron and completely saturate each

hinge with thin C/A glue. e ailerons front surface

should lightly contact the wing during this proce-

dure. Ideally, when the hinges are glued in place, a

1/64” gap or less will be maintained throughout the

lengh of the aileron to the wing panel hinge line.

- Turn the wing panel over and deect the aileron

in the opposite direction from the opposite side.

Apply thin C/A glue to each hinge, making sure

that the C/A penetrates into both the aileron and

wing panel.

- Using C/A remover/debonder and a paper towel,

remove any excess C/A glue that may have accu-

mulated on the wing or in the aileron hinge area.

- Repeat this process with the other wing panel, se-

curely hinging the aileron in place.

- Aer both ailerons are securely hinged, rmly

grasp the wing panel and aileron to make sure the

hinges are securely glued and cannot be pulled out.

Do this by carefully applying medium pressure,

trying to separate the aileron from the wing panel.

Use caution not to crush the wing structure.