User manual

ZERO KIT

Instruction Manual.

81.

82.

83.

- Use Sandpaper to sanding the wing.

- Getting prepare 2 sets of servo hatch for a wing

include W52 (2p cs); W53 (4pcs); W54 (4pcs).

- Install 2 sets of ser vo hatch for by CA glue.

HINGING THE AILERON

Note : e control surfaces, including the ailerons,

elevators, and rudder, are prehinged with hinges in-

stalled, but the hinges are not glued in place. It is

imperative that you properly adhere the hinges in

place per the steps that follow using a high-quality

thin C/A glue.

- Carefully remove the aileron from one of the

wing panels. Note the position of the hinges.

- Remove each hinge from the wing panel and ai-

leron and place a T-pin in the center of each hinge.

Slide each hinge into the wing panel until the T-pin

is snug against the wing panel. is will help en-

sure an equal amount of hinge is on either side of

the hinge line when the aileron is mounted to the

aileron.