User manual

ZERO KIT
32
Instruction Manual.
13.
14.
- Reinstall the servo horn by sliding the connec-
tor over the pushrod wire. Center the throttle stick
and trim and install the servo horn perpendicular
to the servo center line.
COWLING
- Slide the berglass cowl over the engine and line
up the back edge of the cowl with the marks you
made on the fuselage then trim and cut as shown.
1.
2.
- Move the throttle stick to the closed position and
move the carburetor to closed. Use a 2.5mm hex
wrench to tighten the screw that secures the throt-
tle pushrod wire. Make sure to usethreadlock on
the screw so it does not vibrate loose.
15.
16.