User manual
31
+ 0.91 - 1.25 : 4 STROKE.
- Position the engine with the drive washer
(150mm) forward of the rewall as shown.
8.
9.
- Use a pin drill and 4mm drill bit to drill a small
indentation in the mount for the engine mounting
screw.
10.
- Use a drill to drill the four holes in the engine
mount rails.
- On the re wall has the location for the throttle
pusshrod tube (pre-drill).
11.
12.
- Slide the pushrod tube in the rewall and guide
it through the fuel tank mount. Use medium C/A
to glue the tube to the rewall and the fuel tank
mount.
- Connect the Z-bend in the 450mm throttle push-
rod to the outer hole of the carburetor arm.
- Slide the throttle pushrod wire into the tube.
Position the engine between the mounts. Use four
M4x30mm machine screws to secure the engine to
the mount as shown.