User manual

ZERO KIT
26
Instruction Manual.
34.
35.
36.
INSTALLING THE FUSELAGE SERVOS
Because the size of servos dier, you may
need to adjust the size of the precut opening in
the mount. e notch in the sides of the mount
allow the servo lead to pass through.
- Secure the servos with the screws provided with
your radio system.
- Install the rubber grommets and brass collets
onto the throttle servo. Test t the servo into the
aileron servo mount.
THROTTLE SERVO ARM
INSTALLATION
- Install adjustable servo connector in the servo
arm as same as picture below:
2.
1.
Minimum servo spec.
Torque : 80 oz-in (5.8 kg-cm) @ 4.8V; 100 oz-
in (7.2 kg-cm) @ 6.0V
- Use White Glue to keep xed for wing tube.
- Drill to hole for antenna.
- Using Sandpaper Block to sanding around fuse-
lage. Building the fuselage was nished.