User manual

NEMESIS
Instruction Manual.
28
INSTALLING VERTICAL STABILIZER
Using a modeling knife, remove the
covering from over the precut hinge slot
cut into the lower rear portion of the fu-
selage. is slot accepts the lower rudder
hinge.
1.
4.
2.
3.
Hinge
Slide the vertical stabilizer into the slot in
the top of the fuselage. e rear edge of the
stabilizer should be ush with the rear edge
of the fuselage and the lower rudder hinge
should engage the precut hinge slot in the
lower fuselage. e bottom edge of the stabi-
lizer should also be rmly pushed against the
top of the horizontal stabilizer.
Slide the vertical stabilizer back inplace.
Using a triangle, check to ensure that the
vertical stabilizer is aligned 90º to the
horizontal stabilizer.
While holding the vertical stabilizer
rmly in place, use a pen and draw a
line on each side of the vertical stabilizer
where it meets the top of the fuselage.
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
6.
5.
Epoxy
Epoxy