Specifications

9
www.seagullmodels.com
 2) Place your engine onto the engine
mount. Adjust the engine is centered of the
edges of the engine case.
 3) When you are satisfied with the align-
ment, mark the locations of the engine
mounting.
135mm.
MOUNTING THE ENGINE.
 1) Install the pushrod housing through the
predrilled hole in the firewall and into the servo
compartment. The pushrod housing should
protrude 1/4" out past the front of the firewall.
Make a Z-Bend 1/4" from one end of the plain
wire pushrod.
FUEL TANK INSTALLATION.
You should mark which tube is the vent
and which is the fuel pickup when you attach
fuel tubing to the tubes in the stopper. Once
the tank is installed inside the fuselage, it may
be difficult to determine which is which.
Fuel tank.
C/A glue.
4.2mm diameter.
 4) Remove the engine. Using an drill bit,
drill the mounting holes through the engine
mount at the four locations marked.
 6) Attach the Z-Bend in the pushrod wire
to the throttle arm on the carburetor.
 5)
Bolt the engine to the engine mount
using the four machine screws. Double
cheek that all the screws are tight before
proceeding.
Blow through one of the lines to en-
sure the fuel lines have not become kinked
inside the fuel tank compartment. Air
should flow through easily.
vent tube.
Fuel pick-up tube.
Fuel fill tube.
Pushrod wire.
Machine Screw 4x30mm.
Trim and cut.