User manual PC-9 EP 1.3m Seagull (SEAX-8)

PC9-EP. Instruction Manual.
12
! 4) Slide the cowl back over the motor.
! 2) Slide the fiberglass cowl over the en-
gine and line up the back edge of the cowl with
the marks you made on the fuselage then trim
and cut.
INSTALLING THE BATTERY-RECEIVER.
See pictures below.
Battery tray
Tie wrap or rubber band.
The propeller should not touch any part
of the spinner cone. If it does, use a sharp
modeling knife and carefully trim away the
spinner cone where the propeller comes in
contact with it.
! 3) While keeping the back edge of the
cowl flush with the marks, align the front of
the cowl with the crankshaft of the motor. The
front of the cowl should be positioned so the
crankshaft is in nearly the middle of the cowl
opening. Use the spinner backplate as a guide.
Hold the cowl firmly in place using pieces of
masking tape.
! 5) Secure the cowl with the screw pro-
vide with hardware.
Motor.
5.2cm
0.8cm
1cm
2x8mm.
Battery.