User manual PC-9 EP 1.3m Seagull (SEAX-8)

www.seagullmodels.com
11
INSTALLING THE STEERING ARM
SERVO.
Lock tie.
Attach the micro control connector to the
servo arms. Be sure to use the lock tie but it
could free rotation .
! 1) Install the rubber grommets and brass
collets onto the stearing servo. Test fit the
servo into the stearing servo mount.
! 2) Secure the servos with the screws pro-
vided with your radio system.
Because the size of servos differ, you
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
INSTALLING ELECTRIC MOTOR.
Blind nut.
COWLING INSTALLATION.
! 1) Using a pen to mark the points follow-
ing the instruction below.
pushrod wire
C/A glue.
Motor.
Stearing servo.