Specifications

FAIRCHILD PT-19 Instruction Manual
13
INSTALLING THE FUSELAGE SERVOS.
INSTALLING THE SWITCH.
 1) Install the switch into the precut hole
in the fuselage. Use the two screws provided
with the switch to secure it in place.
Open hole
for air intake.
 2) Install the rubber grommets and brass
collets onto the elevator, rudder and throttle
servos. Test fit the servos into the preinstalled
servo tray. Because the size of servos dif-
fer, you may need to adjust the size of the
precut openings in the tray.
 3) Position the servos into the servo tray
with the output shafts orientated as shown
below. Drill 1/16” pilot holes through the tray
for each of the mounting screws.
Install servos arm to servos. Notice the po-
sition of the servo arms on the servos. See
picture below.
Rudder.
Elevator.
Throttle.
Elevator.
Switch.
Throttle.
Elevator.
Rudder.
Elevator.
Switch.
Switch.