Specifications

www.seagullmodels.com
7
Fuel pick-up
tube.
Fuel fill tube.
Vent tube.
Blow through one of the lines to ensure
the fuel lines have not become kinked inside
the fuel tank compartment. Air should flow
through easily.
!
1) Locate and cut out the covering film from
the servo holes in both sides of fuselage.
! 2) Install the rubber grommets and brass
collets onto the elevator servo. Test fit the
servo into the elevator servo mount.
! 3) Secure the servos with the screws pro-
vided with your radio system.
Because the size of servos differ, you may
need to adjust the size of the precut opening
in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
Remove covering.
Right side.
Elevator servo.
Left side.
Elevator servo.
INSTALLING THE FUSELAGE SERVO.
Throttle servo.
Rudder servo.
Servo tray.
Engine .91 - 2 stroke.
Engine 1.25 - 4 stroke.
We recommended to use long servos arm
( 70mm diameter) for all servos without throttle
servo.
ELEVATOR SERVO INSTALLATION.
C/A glue.