Specifications

www.seagullmodels.com
17
! 6) Attach the Z-Bend in the pushrod wire to
the throttle arm on the carburetor. You will need
to remove the throttle arm from the car- buretor
to be able to attach the Z-bend. When
complete, re-attach the throttle arm to the car-
buretor.
! 5) Bolt the engine to the engine mount using
the four machine screws. Double check that
all the screws are tight before proceeding.
4.2mm.
4x30mm.
Engine .91 - 2 stroke.
4x30mm.
Pushrod wire.
Engine 1.25 - 4 stroke.
140mm.
COWLING.
! 1) Slide the fiberglass cowl over the en-
gine and line up the back edge of the cowl with
the marks you made on the fuselage then trim
and cut.
Pushrod wire.
3x10mm.
Trim and cut.