User Manual

3
www.seagullmodels.com
ADDITIONAL ITEMS REQUIRED..
 Engine 33cc-40cc.
 Computer radio with 7servos.
 Glow plug to suit engine.
 Propeller to suit engine.
 Protective foam rubber for radio
system.
 Silicone fuel line.
TOOLS & SUPPLIES NEEDED.
 Thick cyanoacrylate glue.
 30 minute epoxy.
 5 minute epoxy.
 Hand or electric drill.
 Assorted drill bits.
 Modelling knife.
 Straight edge ruler.
 2mm ball driver.
 Phillips head screwdriver.
 220 grit sandpaper.
 90° square or builder’s triangle.
 Wire cutters.
 Masking tape & T-pins.
 Thread-lock.
 Paper towels.
KIT CONTENTS.TS
1 Fuselage
2 Wing Set
3 Tail Set
4 Cowling
5 Main Landing Gear
6 Wing Tube
7 Hardware Set
8 Fiberglass Wheel Pants
9 Canopy
10 Pilot
11 Fuel Tank
Aileron control horn.
INSTALL THE AILERONS CONTROL
HORN.
1) Locate the hardware necessary to install
the control horns for the ailerons.
Fiberglass control horn.
2)Position the Control horn on the Aileron
and use 30-minute Epoxy
Epoxy.
Install the elevator control horn using the
same method as same as the aileron control
horns.
INSTALL ELEVATOR CONTROL HORN.
Fiberglass control horn.