Instructions for use JP-5500030

GEEBEE. Instruction Manual
8
 6) Attach the Z-Bend in the pushrod wire to
the throttle arm on the carburetor.
 5) Bolt the engine to the engine mount using
the four machine screws. Double check that
all the screws are tight before proceeding.
155mm
.
4.2 mm
diameter.
Machine Screw 4x30mm.
Pushrod wire.
INSTALLING THE BATTERY.
Battery.
Tie Wrap.
 1) Install the pushrod housing through the
predrilled hole in the firewall and into the servo
compartment. The pushrod housing should
protrude 1/4" out past the front of the firewall.
Make a Z-Bend 1/4" from one end of the plain
wire pushrod.
MOUNTING THE ENGINE.
 4) Remove the engine. Using an drill bit,
drill the mounting holes through the engine
mount at the four locations marked.
 2) Place your engine onto the engine
mount. Adjust the engine is centered of the
edges of the engine case.
 3) When you are satisfied with the align-
ment, mark the locations of the engine
mounting.
Epoxy.
Battery tray.
Blow through one of the lines to ensure
the fuel lines have not become kinked in-
side the fuel tank compartment. Air should
flow through easily.