Instructions for use JP-5500030
www.seagullmodels.com
15
ξ 1) Using a modeling knife, remove the
covering from over the two main gear mount-
ing slots located in the bottom of the wing.
ξ 2) Insert the 90ΒΊ bend of one main gear
wire into the predrilled hole in one mounting
slot.
INSTALLING THE MAIN GEAR WIRES.
ξ 3) Using the two landing gear straps as a
guide, mark the locations of the four 3 x 10mm
mounting screws onto the wing surface.
Landing gear.
Wheel collar.
Wheel.
Wheel collar.
Remove the
covering.
1mm diameter.
Landing gear.