Instructions for use JP-5500030

www.seagullmodels.com
13
Epoxy.
 3) Peel off the backing from the self adhe-
sive covering strip. Apply the strip to the centre
section of the wing starting from the bottom
trailing edge. Wrap the strip all the way around
the wing until it meets the trailing edge again.
Trim off any excess strip.
Remove the covering.
Remove covering.
Pen.
When cutting through the covering to
remove it, cut with only enough pressure
to only cut through the covering itself. Cut-
ting into the balsa structure may weaken
it.
Masking tape.
INSTALLING THE HORIZONTAL STABILIZER.
Hinge slot.
Center line.