Instructions for Use

SPACE WALKER II Instruction Manual.
8
1) Using a modeling knife, carefully cut off
the rear portion of one of the 3 nylon tubes
leaving 1/2” protruding from the rear of the
stopper. This will be the fuel pick up tube.
2) Using a modeling knife, cut one length of
silicon fuel line. Connect one end of the line to
the weighted fuel pickup and the other end to
the nylon pickup tube.
3) Carefully bend the second nylon tube up
at a 45º angle. This tube is the vent tube. To
set the angle of the vent tube use a lighter or
heat gun to heat the tube (do not melt the tube).
FUEL TANK.
9) Connect the linkage as shown and se-
cure the control wire with a wire keeper.
Repeat the procedure for the other ai-
leron servo.
Vent tube.
Fuel fill tube.
Fuel pickup tube.
INSTALLING THE STOPPER ASSEMBLY.
5) With the stopper assembly in place,
the weighted pickup should rest away from
the rear of the tank and move freely inside the
tank. The top of the vent tube should rest just
below the top of the tank. It should not touch
the top of the tank.
6) When satisfied with the alignment of
the stopper assembly tighten the 3mm x 20mm
machine screw until the rubber stopper ex-
pands and seals the tank opening. Do not
overtighten the assembly as this could cause
the tank to split.
Important:
When the stopper assembly is
installed in the tank, the top of the vent tube
should rest just below the top surface of the
tank. It should not touch the top of the tank.
4) Test fit the stopper assembly into the
tank. It may be necessary to remove some of
the flashing around the tank opening using a
modeling knife. If flashing is present, make
sure none falls into the tank.
Attach the silicone fuel and pressure pipes
to the tank. The lower pipe is the ‘feed’ and the
upper two the ‘pressure and fill’. The fill pipe is
the next pipe.
Servo arm.
Wire keeper.