Instructions for Use

SPACE WALKER II INSTRUCTION MANUAL.
7
Repeat the procedure for the other wing
half.
AILERON LINKAGE.
1) Using a ruler & pen to draw a straight
line as below picture.
2) Locate the two nylon control horns, two
nylon control horn backplates and four
machine screws.
3) Position the aileron horn on the bottom
side of aileron. The clevis attachment holes
should be positioned over the hinge line.
2mm X 20mm.
Control Horn.
Mounting Screws.
Mounting Plate.
Pen.
Straight line.
4) Using a 1mm drill bit and the control
horns as a guide, drill the mounting holes
through the aileron halves.
6) Thread one nylon adjustable control horn
onto each aileron control rod. Thread the
horns on until they are flush with the ends of
the control rods.
7) With the aileron servo centered and the
aileron even with the trailing edge of the wing
attach the clevis to the control horn. Mark the
control wire where it crosses the servo arm
hole.
8) Make a 90-degree bend at the mark and
cut off the excess wire leaving 10mm past the
bend.
5) Mount the control horns by inserting the
screws through the control horn bases and
aileron halves, then into the mounting
backplates. Do not overtighten the screws or
the backplates may crush the wood.
Pen.
Cut.