Instructions for Use

SPACE WALKER II Instruction Manual.
4
5) Turn the wing panel over and deflect the
aileron in the opposite direction from the
opposite side. Apply thin C/A glue to each
hinge, making sure that the C/A penetrates into
both the aileron and wing panel.
6) Using C/A remover/debonder and a paper
towel, remove any excess C/A glue that may
have accumulated on the wing or in the aileron
hinge area.
8) After both ailerons are securely hinged,
firmly grasp the wing panel and aileron to
make sure the hinges are securely glued and
cannot be pulled out. Do this by carefully
applying medium pressure, trying to separate
the aileron from the wing panel. Use caution
not to crush the wing structure.
Work the aileron up and down several
times to “work in” the hinges and check
for proper movement.
7) Repeat this process with the other wing
panel, securely hinging the aileron in place.
1) Carefully remove the elevator from one
of the horizontal stabilizer panels. Note the
position of the hinges.
2) Remove each hinge from the horizontal
stabilizer panel and elevator and place a T-pin
in the center of each hinge. Slide each hinge
into the elevator until the T-pin is snug against
the elevator. This will help ensure an equal
amount of hinge is on either side of the hinge
line when the elevator is mounted to the
horizontal stabilizer panel.
HINGING THE ELEVATORS.
Repeat the procedure for the other ai-
leron servo.
Note:
HINGING THE RUDDER.
1) Test fit the Wing tube into each wing half.
The brace should slide in easily up to the
centreline that you drew. If not, use 220 grit
sandpaper with a sanding block and sand
down the edges and ends of the brace until it
fits properly.
WING ASSEMBLY.
NOTE:We highly recommend using 30 minute
epoxy as it is stronger and provides more
working time, allowing the builder to properly
align the parts. Using fast cure epoxy when
joining the wing halves could result in the glue
drying before the wing halves are aligned
properly which may result in failure of the wing
centre section during flight.
Glue the rudder hinges in place using the
same tectniques used to hinge the ailerons.
Glue the elevator hinges in place using the
same tectniques used to hinge the ailerons.
Apply epoxy glue.