User guide

Seagate Travan 40GB User Guide 13
6. Connect the power cable.
Connect a 4-pin power cable to the back of the
tape drive (see Figure 9). If all the power cables
in your computer are being used by other de-
vices, you can purchase a Y-shaped power-cable
splitter from your computer dealer.
7. Check all cables in your computer system.
Make sure that no cables have loosened during
the installation. Make sure that all cables are
routed so that they will not bind or become
crimped when you replace the cover of your
computer.
8. Reinstall your computer cover.
Your new tape drive is ready for use. However,
you may need to install drivers for your operat-
ing system, as described in step 9.
9. Install drivers (Windows systems only)
The first time you restart your computer after
installing the Travan 40 tape drive, the Windows
Figure 9
TR40IG.P65 01/07/2002, 8:41 AM13