User guide
6: Setting Up & Configuring a Capture Station
84 —
revision 143
CCP-500 (Back View)
1. Tele Button – (Telephoto) Press this button to zoom in.
2. Push Auto Button – (Auto Focus) Press and hold this button to activate the
auto focus function.
3. Wide Button – (Wide Angle) Press this button to zoom out.
4. BLC – (Back Light Compensation) If you press this button while viewing a
backlight subject, the camera will adjust itself to the high contrast lighting.
• BLC mode is switched between ON and OFF by pressing this button.
• If you hold the button down for more than 2 seconds and then release,
the BLC will change to AUTO BLC mode.
5. Shutter Speed Button – Use to select the shutter speed.
6. Power In and Control – Insert the DC power cable here to connect the
camera to the DC power source (DC 12V). You can control the Zoom and
Focus Lens to use Controller.
7. Video Out terminal - Connect this terminal to the video input terminal or an
external input, such as a monitor, TV or VCR.
8. S-Video Out terminal – This is an output terminal for separate Y/C video
signals.
The CAM-CCP-500K camera zooms to X32, but the recommended zoom area
should be less than X16. This is because the zoom past X16 is digital and the
TELE
PUSH
AUTO
WIDE
BLC
SHUTTER
S VIDEO
OUT
VIDEO
OUT
CONTROL
POWER IN
Class 2 Only