User guide

5: CCD/CCTV Video Setup for USB Devices
74 —
revision 143
If your situation requires that you configure these settings yourself, you must
click on the [Save Defaults] push button to save the settings. Note that
BadgeDesigner has its own set of Multimedia Capture module settings apart from
the set shared by ID CredentialCenter and System Administration.
FlashPoint/MCI Video Settings Form
Section/Field Value
Video Board FlashPoint
Input Format S Video
Input Standard NTSC
Video Source 1
Alternate Sync Mode unchecked
High Resolution Capture checked
Flash Type None
Flash Field Delay N/A
The video board name to use for the FlashPoint 3D/3Dx is just “FlashPoint.” (The
capture dialog auto-detects which type of FlashPoint board you have installed.)
FlashPoint/MCI Video I/O Settings Form
Field Value
Flash Brightness 539
Flash Contrast 555
Live Brightness 539
Live Contrast 555
Hue 0
Red N/A
Green N/A
Blue N/A
Saturation 507
Sharpness 0
Gain N/A
Gamma N/A
Offset N/A
Video Output Settings N/A to FlashPoint boards