User guide
5: CCD/CCTV Video Setup for USB Devices
70 —
revision 143
Step 2: Install the F5U208 VideoBus II USB Cable
(Windows 2000)
Notes: This procedure is installing on Windows 2000 only. For Windows XP
installation procedures, please refer to Step 2: Install the F5U208 VideoBus
II USB Cable (Windows XP) on page 66.
Do NOT use the USB VideoBus II Installation CD. Instead, use the drivers
on Disc 2 of the B.A.S.I.S. Installation Disk Set. The Windows 2000 drivers
are located in the D:\Belkin F5U208 USB Drivers\Windows 2000
directory, where D:\ is your CD-ROM drive.
1. CLOSE ALL WINDOWS PROGRAMS before installing the VideoBus
software. The installation will not work correctly if any other Windows
programs are open during the installation.
2. Connect the camera and CCTV switcher (if necessary) to the Belkin USB
VideoBus II.
3. Connect the Belkin USB VideoBus II to a free USB port on your computer,
and then connect the camera to a power source.
4. The hardware wizard will recognize the device, and the Welcome to the
Found New Hardware Wizard window opens. Click [Next].
5. Verify the Search for a suitable driver for my device (recommended)
radio button is selected and click [Next].