User guide

4: CCD/CCTV Video Setup
58 —
revision 143
Step 5: Install FlashPoint Software
1. If you have not already done so, run setup.exe from the first FlashPoint
setup disk. In the Select Components dialog, select only the FlashPoint
FPG3D Capture Application.
2. Reboot your computer if prompted to do so.
Step 6: Connect Your Video Camera(s) to Your
FlashPoint 3D Board
The FlashPoint board connections diagram that follows applies only to the Lite
version of Flashpoint 3D. Connect your camera(s) to your FlashPoint 3D Lite
board using the cable(s) identified in Step 1: Check to Make Sure You Have All
the Required Video Hardware on page 53. Refer to your FlashPoint User’s
Manual and camera user guide for assistance.
Notes: The board must be installed into Slot # 1 or it will not work!
Be sure to also connect your SVGA monitor to the FlashPoint 3D board,
NOT to the on-board video port!