User guide

Installation & Setup User Guide
revision 143 — 53
Chapter 4: CCD/CCTV Video Setup
Configuring Video Hardware & Software
This procedure will verify that your system video capture board and required
Windows drivers are configured properly for live video capture/CCTV video
with one of the following Integral Technologies video capture boards:
• FlashPoint 3Dx Lite PCI
• FlashPoint 3Dx Pro PCI
• FlashPoint 3D Plus PCI 8 MB
• FlashPoint 3D Pro PCI
Those with other capture boards should refer to Appendix J: CCD/CCTV Video
Setup for Discontinued Hardware. Be sure to perform Step 1: Check to Make
Sure You Have All the Required Video Hardware through Step 3: Install the
FlashPoint VGA Display Adapter Driver before you install any Integral™
Technologies FlashPoint™ software. The latest FlashPoint 3Dx software is
available for download from Integral’s web site: http://www.integraltech.com/
support.html. The most current version is 2.03, which is what the 3Dx systems
ship with.
The FlashPoint User’s Manual and accompanying Setup software diskettes are
required for the procedures outlined in this chapter. (The FlashPoint User’s
Manual referenced in this user guide is the September 2001 version.) You may
also need your Windows 2000/Windows XP CD or a FlashPoint Display Drivers
diskette from Integral Technologies.
Step 1: Check to Make Sure You Have All the Required
Video Hardware
Refer to the “FlashPoint Cables” chapter of the FlashPoint User’s Manual for the
video input cable requirements of your board.
If you’re setting up a capture station you need the following hardware: