User guide

Installation & Setup User Guide
revision 143 — 303
• Direct connection to the COM port
• 38400 bits per second (bps)
• 8 data bits
• NO parity
• 1 stop bit
• NO flow control
To do this using HyperTerminal:
1. Click the Windows Start button, then select Programs > Accessories >
Communications > HyperTerminal.
2. Type SafeNet Speed as the Name of the connection.
3. Select an icon to represent the connection, then click [OK].
4. In the Connect Using dropdown listbox, select the COM port of the
workstation that the SafeNet Speed box is connected to, then click [OK].
•In the Bits per second field, select ‘38400’.
•In the Data bits field, select ‘8’.
•In the Parity field, select ‘None’.
•In the Stop bits field, select ‘1’.
•In the Flow Control field, select ‘None’.
5. Close HyperTerminal.
• When prompted, click [Yes] to disconnect the session.
• When prompted, click [Yes] to save the session.
6. Reopen the session by clicking the Windows Start button, then selecting
Programs > Accessories > Communications > HyperTerminal > SafeNet
Speed session.
7. Press <Enter>, and information will appear in the window.
8. Press <c> and then press <Enter> to enter the Configuration menu.
9. Type IRE as the initial password and press <Enter>.
10. Press <p> to create a new password.
11. Enter the new password and press <Enter>.
12. Enter the new password again and press <Enter>.
13. For each item, enter the following value if not already selected:
Item Value
Encryptor operating mode Public Key
Encryptor type Host encryptor
IP processing mode FILTER
Non-IP processing mode BYPASS
Level 2 bridging DISABLED