User guide

J: CCD/CCTV Video Setup for Discontinued Hardware
260 —
revision 143
Consult the ID CredentialCenter/System Administration User Guide on how to
make those adjustments in the Workstations folder.
• Video Colors and Video Sync Mode. Video Verification displays live
video using the color adjustments and sync mode configured in the FPG32
application which shipped with your FlashPoint board. Consult your FlashPoint
User’s Manual on how to make those adjustments. (The sync mode option is
configured in the FPG32 application’s Advanced Configuration window. When
enabled it causes unstable video coming from a VCR to stop jumping up and
down and settle down into a stable picture, though there will be a narrow strip of
static across the bottom.)
Video Software Settings for a Capture Station
The Multimedia Capture window has its own set of Video Source, Input
Standard, Input Format, Color and Sync Mode settings completely separate from
the FPG32 application. To adjust the Multimedia Capture settings, refer to
Chapter 6: Setting Up & Configuring a Capture Station. More information is
available in the BadgeDesigner User Guide, the ID CredentialCenter User Guide
and the System Administration User Guide.
• Default Camera Settings. The following settings are for a normal office
environment. They may need to be changed based on several variables in the
capture environment (distance, lighting, backgrounds, wall color, etc.).
Consult your camera user guide for information about manual overrides to the
Hitachi VK-C77U camera. Most standard office environments will not need to
use the manual adjustments or the Enhance Flash Lighting kit (EHK-283). The
Enhance Flash Lighting kit is intended for abnormally dark environments or
conditions in which the lighting is constantly changing.
• Multimedia Capture Settings. In the Multimedia Capture module of the ID
CredentialCenter, System Administration and BadgeDesigner applications, the
following settings are made at the factory. If you have purchased a turnkey
B.A.S.I.S. system, these settings will have been configured for you. If you have
not pressed the save user defaults button, the following settings default to values
suitable for the Saerim camera (For more information, refer to Chapter 4: CCD/
CCTV Video Setup on page 53.) Those with a Hitachi camera must change them
to the values listed is the table that follows.