User guide

J: CCD/CCTV Video Setup for Discontinued Hardware
258 —
revision 143
Step 7: Connect Your Video Camera(s) to Your
FlashPoint Board
Connect your camera(s) to your FlashPoint board using the cable(s) identified in
Step 1: Check to Make Sure You Have All the Required Video Hardware on
page 251. Refer your FlashPoint User’s Manual and camera user guide for
assistance.
Notes: The board must be installed into slot # 1 or it will not work!
Be sure to also connect your SVGA monitor to the FlashPoint board, NOT to
the on-board video port!
Step 8: Verify That Your Video Board and Drivers Are
Working Properly
This can be done easily and quickly using the FPG32 application which ships
with your FlashPoint board. Note that if FPG32 is unable to display video,
neither will B.A.S.I.S.; i.e., the FPG32 application can be used for testing your